Page 4
ASSEMBLY INSTRUCTIONS
1
2
Attach the leg connector bracket to two table legs to by using two 1/4"x18 mm bolts and washers as
shown in
. Guide the bolts through the holes in the leg connector bracket, into the pre-drilled
holes in the leg.
F
2
Hand tighten only 2-3 turns.
igure
Place the table top upside down on a flat, non-abrasive surface.
igure
Attach a table leg to the table top by
using three 1/4"x28 mm bolts and washers as shown in
. Guide the bolts through the holes in
the table leg into the pre-drilled holes in the table top.
Repeat for the
other leg.
F
1
Hand tighten only 2-3 turns.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Over tightening may strip bolts. With the
help of another person, turn the table in the upright position.
Do not over tighten.
Cover all bolts with covers.
F
1
igure
Figure 2
D
F
C
B
FOOT CAP
A
E
F
G
G
