Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Carefully place the chair frame (A) upside down on a non-abrasive surface.
Assemble the T rocker(B) to the chair frame(A) with steel panel(D) and Bolts(AA) and
Washer(BB) and M8 Spring gasket (CC) and M8 Nut(DD) by using open wrench(GG),
then cover the bolts with bolt covers (EE and FF) as shown in Figure 1.
Figure 1
Step 2. Place the chair frame (A) into the base( C ) as shown in Figure 2 .
Figure 2
Page 6 of 7
Summary of Contents for BRIGDN5PCBR-SU
Page 1: ...Page 2 of 7 ...
Page 3: ...Page 3 of 7 ...
Page 4: ...Page 4 of 7 ...
Page 11: ...Step 3 Your chair is now ready to use Figure 3 Figure 3 Page 7 of 7 ...
