Page 4
ASSEMBLY INSTRUCTIONS
1
2
C
Place the table top upside down on a flat, non-abrasive surface.
igure
Attach the assembled base to the table
top by using the bolts and washers as shown in
. Guide the bolts through the holes in the legs, into
the pre-drilled holes in the table top.
F
2
Hand tighten only 2-3 turns.
B
Attach a leg to the two leg connector brackets by carefully guiding the bolts already in place on the table
leg (each leg has four bolts) through the holes in the leg connector brackets. Add a washer and a nut
to the end of each bolt.
Repeat for the other three legs.
Hand tighten only 2-3 turns.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench
to tighten all nuts and bolts.
: Each bolt and nut must be tightened a few revolutions at a time. In order
to apply equal pressure to all joints, we recommend working in a cross corner (X fashion). Repeat until all
nuts and bolts are tight.
Over tightening may strip bolts. Cover all nuts and bolts with
covers.
Note
Do not over tighten.
F
1
igure
FOOT CAP
D
Figure 2
I
H
F
A
G
E
F
