INSTALLATION
1. Identify parts packed in carton against the parts list. Remove all protective materials and
set parts on a flat, non-abrasive surface.
2. Attach the back panel to side panels by using four 1/4"x40 mm bolts and washers as
shown in Figure 2. Guide bolts through holes in back panel, into pre-drilled holes in the
side panels.
Hand tighten only.
Figure 2
3. Attach the middle support to the side panels by using two 1/4"x15 mm bolts and
washers as shown in Figure 3. Guide bolts through the holes in the middle support, into
pre-drilled holes in the side panels.
Hand tighten only.
Figure 3
4. Attach the "L" connector to right side panel by using a 1/4"x15 mm bolt and washer as
shown in Figure 4. Guide bolt through hole in "L" connector, into pre-drilled hole in the
right side panel.
Do not over tighten.
Figure 4
