15
When you enter this control, the screen below will be displayed.
The factory default of the password is “0000”.
To enable parental control, input the password, press
▼
button to focus on
OK
key, and press
ENTER
. (select
Cancel
if you want to exit)
After entering, the following screen will be shown.
Channel Lock:
To lock channels. Use
◄►
to select the channel you want to lock, and then
press
ENTER
to lock or unlock it.
Change Password:
To change the password, press
ENTER
and enter the
password again. Press
ENTER
, and the following screen appears.
Enter the new password, use
▼
to move the cursor down, and then enter the new password
again, press
OK
to confirm or
Cancel
to exit.
Note:
Please make sure you remember your new password after changing, because you cannot
recall the default setting of the password by any selection.
Clear All:
To clear all the locks set before, press
ENTER
.
Press
MENU
to return to the previous page.
‧
Color Temperature:
To select the color temperature from Warm, Cold, Normal or User. (If you
select User, you can adjust the degree of R, G, B in Color Temp. to suit your personal
preference.)
‧
Back Light:
To adjust the luminance of the back light.
‧
Aspect Ratio:
To select image size between Normal, Full, Wide1, Wide2, Wide3,
4:3, 16:9, and No scale.
‧
OSD Timeout:
To setup the display time of OSD. (5, 15, 45, and 60 seconds)
‧
Memory Recall:
To restore the factory default settings.
E
n
g
lis
h
Summary of Contents for JT01-32U1-000G
Page 1: ...JT2001131680P ...
Page 9: ...REMOTE CONTROL 4 English ...
Page 39: ...CONTROL REMOTO 4 Español ...
Page 69: ...TELECOMMANDE 4 Français ...
