2
Eng
lish
Regulatory Information
FCC Compliance Statement
1
This device complies with part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Additional Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
•
Consult the dealer or an experienced technician for help
Warning
: The Federal Communications Commission warns that changes or modifi-
cations of the equipment not expressly approved by the party responsible for compli-
ance could void your authority to operate the equipment.
1
applies only to products purchased in the United States of America
DOC Compliance Notice
1
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the Radio Interference Regulations of the Cana-
dian Department of Communications.This device complies with Canada ICES-003
Class B.
CE Conformity Statement
2
This device is in conformity with the requirements of EU Council Directive 2004/108/
EC on the approximation of the laws of the Member States relating to electromag-
netic compatibility and Directive 2006/95/EC on the harmonization of the laws of
Member States relating to electrical equipment for use within certain voltage limits.
Hannspree cannot accept responsibility for any failure to satisfy the requirements
resulting from a non-recommended modification of the device.
1
applies only to products purchased in Canada
2
applies only to products purchased in the European Union