Hanna Instruments HI 8734, Instruction Manual

Page: 9 / 11

17 16
CALIBRATION SOLUTIONS
HI 7030L 12880 µS/cm, 500 mL bottle
HI 7030M 12880 µS/cm, 230 mL bottle
HI 7031L 1413 µS/cm, 500 mL bottle
HI 7031M 1413 µS/cm, 230 mL bottle
HI 7033L 84 µS/cm, 500 mL bottle
HI 7033M 84 µS/cm, 230 mL bottle
HI 7034L 80000 µS/cm, 500 mL bottle
HI 7034M 80000 µS/cm, 230 mL bottle
HI 7035L 111800 µS/cm, 500 mL bottle
HI 7035M 111800 µS/cm, 230 mL bottle
HI 7039L 5000 µS/cm, 500 mL bottle
HI 7039M 5000 µS/cm, 230 mL bottle
HI 7032L 1382 ppm (mg/L), 500 mL bottle
HI 7032M 1382 ppm (mg/L), 230 mL bottle
HI 7036L 12.41 ppt (g/L), 500 mL bottle
HI 7036M 12.41 ppt (g/L), 230 mL bottle
CONDUCTIVITY PROBES
HI 76301D Conductivity probe with 1m (3.3') cable and DIN
connector
HI 76302W Conductivity probe with built-in temperature sensor,
1m (3.3') cable and DIN connector
OTHER ACCESSORIES
ChecktempC
Electronic thermometer (range: -50.0 to 150.0°C)
HI 710015 Shockproof rubber boot, blue
HI 710016 Shockproof rubber boot, orange
HI 710022 Spare protective case
ACCESSORIES
When the battery becomes weak the meters will display an additional
blinking decimal point.
When the low battery indicator appears, the battery has only a few
hours left. A low battery will result in unreliable measurements.
It is recommended to replace the battery immediately.
Battery replacement must only take place in a nonhazardous area
using a 9V alkaline battery.
Unscrew the three screws on the rear of the meter, remove the battery
compartment cover and replace the 9V battery with a new one.
Make sure the battery contacts are tight and secure before replacing
the cover.
BATTERY REPLACEMENT