27
PC INTERFACE
PC INTERFACE
PC INTERFACE
PC INTERFACE
PC INTERFACE
Data transmission from the instrument to the PC can be done with the
HI 92000
Windows
®
compatible software (optional).
HI 92000
also
offers graphing and on-line help feature.
Data can be exported to the most popular spreadsheet programs for
further analysis.
To connect your instrument to a PC, use a standard USB cable connector.
Make sure that your instrument is switched off and plug one connector to
the instrument USB socket and the other to the USB port of your PC.
Note:
If you are not using Hanna Instruments
HI 92000
software,
please see the following instructions.
SENDING COMMANDS FROM PC
It is also possible to remotely control the instrument with any terminal
program. Use a standard USB cable to connect the instrument to a PC,
start the terminal program and set the communication options as follows:
8, N, 1, no flow control, 9600 baud rate.
COMMAND TYPES
To send a command to the instrument follow the next scheme:
<command prefix> <command
> <CR>
where:
<command prefix> is a 16 ASCII character
<command> is the command code.
Note:
Either small or capital letters can be used.
SIMPLE COMMANDS
RNG
Is equivalent to pressing
RANGE
CAL
Is equivalent to pressing
CAL
CFM
Is equivalent to pressing
CFM
UPC
Is equivalent to pressing the
UP
arrow key
DWC
Is equivalent to pressing the
DOWN
arrow key
LOG
Is equivalent to pressing
LOG
RCL
Is equivalent to pressing
RCL
SET
Is equivalent to pressing
SETUP
CHR xx
Change the instrument range according with the parameter
value (xx):
• xx=01 pH range/0.01 resolution
• xx=02 mV range
