METER SETUP
•
To enter Setup MODE:
press
SET
button located inside the battery
compartment.
•
To switch between “
°
C“ or “
°
F“:
press
ON/OFF
( )
.
Long press
ON/OFF
button once to save and continue to auto-off settings.
•
To cycle through the Auto-Off choices:
press
ON/OFF ( )
.
Long press
ON/OFF
button once to save and continue to normal operation.
BATTERY REPLACEMENT
If the display shows battery level “
0%
” it means the battery charge is not enough
to guarantee good measurements and the Battery Error Prevention System (BEPS)
turns the meter off. Immediately replace the batteries with new ones.
Battery replacement must only take place in a non-hazardous area.
The batteries are accessed by opening the battery cover on the back of the
instrument.
Replace the three 1.5V AAA alkaline batteries located in the battery compartment,
observing the polarity on the rear of the instrument.
Replace the battery cover making sure that the gasket is in place.
INTENDED USE
The thermometers are waterproof and are rated IP65.
The meters are specifically designed for measuring the temperature
in all areas of the food sector.
Both air temperature and product internal temperature can be measured with
these thermometers.
The probe shaft is designed for continuous contact with foodstuffs in accordance
with Regulation (EC) 1935/2004.
Refer to the probe section of this manual for more information on the available
probes.
TEMPERATURE PROBES
The temperature probes are pre-calibrated at the factory and ready-to-use. These
interchangeable probes make it possible to switch from one probe to another
within the family without requiring recalibration.
Note: To clean the meter and the probe, do not use aggressive
detergents. It is recommended to use water.
QR9350011 04/18
SET
button
