HI9350011
Portable K-Type Fast Response Thermometer for
Foodcare Products
SPECIFICATIONS
•
RANGE*
-50.0 to 199.9 ºC ; 200 to 300 ºC
-58.0 to 399.9 ºF ; 400 to 572 ºF
•
METER ACCURACY
±0.4 ºC (-50.0 to 300 ºC)
@ 23.0 °C ±5 °C ±0.7 ºF (-58.0 to 572 ºF)
•
PROBE ACCURACY
±1.6 ºC (-50.0 to 300 ºC)
FC766C1
±2.9 ºF (-58.0 to 572 ºF)
*The measurement range may be limited by probe type, and applies to the probe shaft.
OPERATIONAL GUIDE
•
To switch ON and OFF:
press
ON/OFF
( )
.
•
To take measurements:
connect a suitable temperature probe to the meter.
At start-up the thermometer displays all LCD segments for a few seconds,
followed by the percentage indication of the remaining battery life. It then
enters CAL Check mode followed by measurement mode.
If a temperature probe is plugged in, the meter displays the measured
temperature.
If reading is slightly beyond the measurement range, the meter flashes the
closest full-scale value.
To switch the meter
OFF
, press the
ON/OFF
key.
•
For auto-off feature:
To save battery life, each model is provided with an auto-off feature, which
switches the instrument off after a certain period of non use.
The auto-off feature can be set in 3 modes from
SETUP MENU
: 8 minutes,
60 minutes or disabled.
•
Calibration Check mode:
The meter is provided with an automatic CAL Check feature at start-up, which
allows the user to check the instrument calibration status. If the meter is
calibrated, the display will stabilize and show “
0.0
°C
”
(±0.3 °C)
for a
few seconds.
Warning messages:
• “
NO PROBE
“
message
: when the probe is not connected or the signal is
interrupted.
• “
Err
“
message
: if during Calibration Check the meter displays more than
±0.3 °C. Contact your local Hanna Instruments Office for recalibration.
•
DAMAGED PROBE message
: when the readings are very far from the
measurement range, the probe may be damaged. The display shows
blinking dashes and “
NO PROBE
” message is displayed.
Quick Reference Guide
