Quick Guide
Fleta 4
Cat. No. : FL-4
Check the rotor is firmly tightend onto
the motor shaft.
Check the Rotor Locking
After relocating the device or loading the
rotor, balance them by using
a leveler.
If necessary, level the device by adjusting the
‘Leveling foot’ on the bottom of the device.
Balancing the Centrifuge and Rotor
Check the cushion rubbers in
the sleeves (AL15-12, AL15-24)
before use. When reinserting,
must insert it in the correct
direction.
Spread the grease lightly on
the bucket where it contacts
the rotor and the pivot.
Clean the chamber and
rotor by wiping with a cloth
soaked in mild detergent
and dry completely.
Check the Cushion Rubbers Care of Swing-Out Rotor
Cleaning
Check the rotor, buckets and tubes are free
of scratch and crack before operation.
Check the Accessories for Abnormalities
Load tubes symmetrically into the rotor
with identical amount.
Load Tubes Symmetrically
Allow a safety clearance of 30 cm around the
centrifuge during operation.
If the centrifuge lid cannot be opened, insert the provided
T-wrench into the emergency release hole on the right side
of the device and turn it clockwise.
(Before activating emergency open, switch off the device
and wait for the rotor to stop.)
Allow a Safety Clearance of 30 cm
Emergency Lid open
AL15-12
12 x 15 ml / Max. 4k (Rotor ID : 3)
AL15-24
24 x 15 ml / Max. 4k (Rotor ID : 4)
S50-6
6 x 50 ml Round / Max. 4k (Rotor ID : 2)
S85-4
4 x 85 ml Round / Max. 4k (Rotor ID : 1)
30 cm
30 cm
30 cm
Swing-out Rotors
Fixed-angle Rotors
500VA
220~240V
50/60Hz
Rev.0
Proudly made by Jiyoung Shim, Hyewon Jeong
Order & Inquiry
l +82-2-3452-9996 l [email protected] l www.ihanil.com
Service
l +82-2-3452-8966 l [email protected]
Switch off the device after use.
Unplug the power plug before
cleaning or unused for a long
period of time.
Check the wall outlet is
earth grounded, surge-
protected andcan supply
enough power.
Connect the device to voltage sources
which correspond to the power require-
ments on the label attached to the device.
Switch Off the Device
Grounded Outlet
Check the Line Voltage
Maintenance
Electrical Safety
Rotor
Cautions For Use
Before Operation
After Operation
