Hangar 9 Twist Plug-N-Play, Assembly Manual

Page: 7 / 16

7
Required Parts
• Fuselage • Propeller
• Spinner
• #4 x 5/8" sheet metal screw (2)

Step 1
Remove the propeller nut and washer from the engine.
Position the drive washer so it is keyed onto the engine
shaft. Slide the spinner backplate onto the engine shaft,
and then slide the propeller into position.

Step 2
Slide the washer and thread the nut onto the engine shaft.
Rotate the propeller clockwise so it is resting against the
lugs of the spinner backplate. Use a crescent wrench to
tighten the propeller nut. Do not use pliers, as the nut will
not be tight enough, and could come loose.
Note : It is suggested to read the engine
instructions included with your
Twist™ Plug-N-Play™ at this time to learn
more on the care and operation of your
Evolution engine.

Step 4
Locate the two #4 x 5/8" sheet metal screws. Position the
spinner cone onto the spinner backplate, making sure
it keys into the backplate. Use the screws and a Phillips
screwdriver to secure the spinner cone to the backplate.
Section 3: Propeller and Spinner