hOOKing UP the stArter Wires
1. It will be necessary to attach a male Tamiya connector to the starter wires. We have included this wire and connector with
the Starter Source for your convenience.
2. It will be necessary to cut back the starter wires to your desired length to attach to the Starter Source.
3. Keep in mind when attaching to the male Tamiya connector and wire that the black wire with the white stripe is positive
(+) and the solid black wire is negative (–).
4. After cutting through both starter wires at the desired length, strip each wire back 3/8”.
5. Slide one rubber battery terminal insulator over each wire.
6. Tin the starter wires, using a soldering iron.
7. Crimp the red lead wire attached to the male Tamiya connector to the white striped starter wire, then solder.
8. Crimp the black lead wire to the solid black starter wire, then solder.
9. After the solder joint cools, slide the rubber terminal insulator over the terminal.
10. Once you have completed assembly of the Starter Source, connect the male Tamiya connector from the starter to the
female Tamiya connector in the rear of the case.
11. After the battery has been charged (see below), attach together the Tamiya connectors. Push the
starter button
and the
starter should engage and rotate in a clockwise direction when viewed from the cone end.
chArging the BAtterY
We recommend using a 12V 130mAh Overnight Charger (HAN166) for charging your PowerPro Starter Source. Normal charge
time is approximately 8–10 hours.
noTice:
When using another charger source, consult the instruction manual so you charge the battery at the correct charge
rate, including fast charges. Charging the battery incorrectly can result in damage to the battery and serious injury and fire
may also result.
© 2014 Horizon Hobby, LLC. Hangar 9, PowerPro and the Horizon Hobby Logo are trademarks or registered trademarks of Horizon Hobby, LLC.
Revised 04/2014 | 5383.1X
advised to return the Product immediately in new and unused
condition to the place of purchase.
law -
These terms are governed by Illinois law (without
regard to conflict of law principals). This warranty gives
you specific legal rights, and you may also have other rights
which vary from state to state. Horizon reserves the right to
change or modify this warranty at any time without notice.
WArrAntY serVices
Questions, assistance, and services -
Your local hobby store
and/or place of purchase cannot provide warranty support
or service. Once assembly, setup or use of the Product has
been started, you must contact your local distributor or
Horizon directly. This will enable Horizon to better answer
your questions and service you in the event that you may
need any assistance. For questions or assistance, please
visit our website at www.horizonhobby.com, submit a
Product Support Inquiry at https://horizonhobby.quickbase.
com/db/bghj7ey8c?a=GenNewRecord, or call the toll free
telephone number referenced in the Warranty and Service
Contact Information section to speak with a Product Support
representative.
inspection or services -
If this Product needs to be
inspected or serviced and is compliant in the country you
live and use the Product in, please use the Horizon Online
Service Request submission process found on our website
or call Horizon to obtain a Return Merchandise Authorization
(RMA) number. Pack the Product securely using a shipping
carton. Please note that original boxes may be included,
but are not designed to withstand the rigors of shipping
without additional protection. Ship via a carrier that provides
tracking and insurance for lost or damaged parcels, as
Horizon is not responsible for merchandise until it arrives
and is accepted at our facility. An Online Service Request is
available at http://www.horizonhobby.com/content/_service-
center_render-service-center. If you do not have internet
access, please contact Horizon Product Support to obtain
a RMA number along with instructions for submitting your
product for service. When calling Horizon, you will be asked to
provide your complete name, street address, email address
and phone number where you can be reached during business
hours. When sending product into Horizon, please include
your RMA number, a list of the included items, and a brief
summary of the problem. A copy of your original sales receipt
must be included for warranty consideration. Be sure your
name, address, and RMA number are clearly written on the
outside of the shipping carton.
noTice: do not ship li-po batteries to horizon. if you have
any issue with a li-po battery, please contact the appropri-
ate horizon product support office.
warranty requirements - for warranty consideration,
you must include your original sales receipt verifying the
proof-of-purchase date.
Provided warranty conditions have
been met, your Product will be serviced or replaced free of
charge. Service or replacement decisions are at the sole
discretion of Horizon.
non-warranty service - should your service not be covered
by warranty, service will be completed and payment will
be required without notification or estimate of the expense
unless the expense exceeds 50% of the retail purchase
cost.
By submitting the item for service you are agreeing to
payment of the service without notification. Service estimates
are available upon request. You must include this request
with your item submitted for service. Non-warranty service
estimates will be billed a minimum of ½ hour of labor. In
addition you will be billed for return freight. Horizon accepts
money orders and cashier’s checks, as well as Visa, Master-
Card, American Express, and Discover cards. By submitting
any item to Horizon for service, you are agreeing to Horizon’s
Terms and Conditions found on our website
http://www.horizonhobby.com/content/_service-center_ren-
der-service-center.
aTTenTion: horizon service is limited to product compli-
ant in the country of use and ownership. if received, a
non-compliant product will not be serviced. further, the
sender will be responsible for arranging return shipment of
the un-serviced product, through a carrier of the sender’s
choice and at the sender’s expense. horizon will hold non-
compliant product for a period of 60 days from notification,
after which it will be discarded.
WArrAntY And serVice cOntAct inFOrMAtiOn
Country of Purchase
Horizon Hobby
Contact Information
Address
United States of
America
Horizon Service Center
(Repairs and Repair Requests)
servicecenter.horizonhobby.
com/RequestForm/
4105 Fieldstone Rd
Champaign, Illinois, 61822 USA
Horizon Product Support
(Product Technical Assistance)
www.quickbase.com/db/
bghj7ey8c?a=GenNewRecord
888-959-2306
Sales
888-959-2306
2-YeAr LiMited WArrAntY
what this warranty covers -
Horizon Hobby, LLC, (Horizon)
warrants to the original purchaser that the product pur-
chased (the “Product”) will be free from defects in materials
and workmanship for a period of 2 years from the date of
purchase.
what is not covered -
This warranty is not transferable and
does not cover (i) cosmetic damage, (ii) damage due to acts
of God, accident, misuse, abuse, negligence, commercial use,
or due to improper use, installation, operation or mainte-
nance, (iii) modification of or to any part of the Product, (iv)
attempted service by anyone other than a Horizon Hobby
authorized service center, (v) Product not purchased from an
authorized Horizon dealer, or (vi) Product not compliant with
applicable technical regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON
MAKES NO OTHER WARRANTY OR REPRESENTATION, AND
HEREBY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES,
INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. THE PURCHASER ACKNOWLEDGES
THAT THEY ALONE HAVE DETERMINED THAT THE PRODUCT
WILL SUITABLY MEET THE REQUIREMENTS OF THE PURCHAS-
ER’S INTENDED USE.
purchaser’s remedy -
Horizon’s sole obligation and
purchaser’s sole and exclusive remedy shall be that Horizon
will, at its option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective. Horizon reserves the
right to inspect any and all Product(s) involved in a warranty
claim. Service or replacement decisions are at the sole
discretion of Horizon. Proof of purchase is required for all
warranty claims. SERVICE OR REPLACEMENT AS PROVIDED
UNDER THIS WARRANTY IS THE PURCHASER’S SOLE AND
EXCLUSIVE REMEDY.
limitation of liability -
HORIZON SHALL NOT BE LIABLE FOR
SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAM-
AGES, LOSS OF PROFITS OR PRODUCTION OR COMMERCIAL
LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH CLAIM
IS BASED IN CONTRACT, WARRANTY, TORT, NEGLIGENCE,
STRICT LIABILITY OR ANY OTHER THEORY OF LIABILITY, EVEN
IF HORIZON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES. Further, in no event shall the liability of Horizon
exceed the individual price of the Product on which liability is
asserted. As Horizon has no control over use, setup, final as-
sembly, modification or misuse, no liability shall be assumed
nor accepted for any resulting damage or injury. By the act of
use, setup or assembly, the user accepts all resulting liability.
If you as the purchaser or user are not prepared to accept the
liability associated with the use of the Product, purchaser is
