10
Section 2: Aileron Servo Installation
Step 7
Use a piece of string with a small weight (such as a wheel
collar) attached as a device to pull the servo lead through
the wing. Lower the weight through the opening at the
root of the wing as shown.
Step 8
Stand the wing on the tip and allow the weight to drop
through the wing until it appears in the opening for the
servo leads. It may require a little help to pass by the
wing ribs in the form of slightly shaking the wing.
Step 9
Tie the string onto the servo extension. Gently pull the
extension through the wing using the string. Untie the
string when the servo lead has been pulled through. Use
tape to secure the servo lead to the wing to prevent it
from falling back into the wing panel.
Step 10
Place the hatch cover in position in the aileron opening.
Measure in 1/8" on all four sides of the hatch. Drill four
1/16" holes at the intersections of the lines as shown.
Note
: Drill through the servo hatch and the
underlying hatch mounts. Use caution not to
accidentally drill through the top of the wing.
Photo for Step 9
Photo for Step 9
