29
Step 6
Install one of the #2 x 1/2" screws in a hole drilled, and
then remove it. Place 2–3 drops of thin CA into the hole
to harden the wood. This will eliminate the potential of the
screw pulling out of the wood. Repeat this for each of the
three holes.
Step 7
Attach the control horn using three #2 x 1/2" screws.
Step 8
Center the elevator servo electronically using the radio
system. Install a servo arm onto one of the elevator
servos. Physically place the elevator control surface in
neutral. Mark the pushrod where it crosses the holes in
the servo arm.
Step 9
Bend the wire 90 degrees at the mark made in the
previous step. Cut the wire 1/2" above the bend.
Step 10
Slide the wire through the outer hole in the elevator servo
arm. Secure the wire using a nylon wire keeper.
Note
: The servo arm will need to be drilled
out using a 7/64" drill bit to accept the
control rod.
Step 11
Repeat Steps 3 through 10 for the remaining elevator
half and rudder.
Section 13 – Linkage Installation
