❑
22. Insert the rudder pushrod into the fuselage, threaded end
first. The threaded rod exits the fuselage at the lower left
opening in the fuselage. Thread a clevis onto the threaded
rod 16 full turns. Then attach the clevis to the rudder
control horn at the second to the outer-most hole.
❑
23. Center the elevators and rudder and, using a felt tipped
pen, place a mark on the unthreaded end of the pushrods
where they pass the respective servo arms.
❑
24. Using Z-bend pliers, make a Z-bend at the marked
locations on both the elevator and rudder pushrods.
Cut off the excess rod.
❑
25. Insert the Z-bend into the servo arm as shown. It may be
necessary to enlarge the holes in the servo arm slightly to
accept the Z-bend.
❑
26. Install the throttle pushrod using the same method.
Note:
It will be necessary to drill a 1/8" hole in the
firewall in the correct position to allow the pushrod to
attach to the throttle arm. Be careful not to drill into the
fuel tank when you drill this hole.
33
Section 12: Installing The Linkages
CONTINUED
Summary of Contents for J-3 Piper Cub
Page 44: ...HAN1501 ...
