Hangar 9 Extra Easy XE2, Instruction Manual

Page: 9 / 24

9
Section 4: Installing the Propeller on the
Evolution Trainer Engine
Step 3. Connect the rudder and elevator pushrod clevises to
the pre-installed control horns. Install the clevises into the hole
furthest away from the control surface (see illustration). Secure
each clevis to the control horn by snapping the clevis pin into
the hole. To prevent the clevises from accidentally opening in
flight make sure the clevis keeper is slid up onto the clevis.
Step 1. Remove the prop nut and washer from the Evolution
engine, noting the position of the washer and flywheel.
Step 2. Locate the spinner and three self-tapping screws
included in your Xtra Easy 2™ RTF kit.
Clevis Keeper
Clevis Keeper
Step 3-3
The rudder pushrod
is positioned above
the horizontal stabi-
lizer.