46
4
5
6
Using a drill and 1/16-inch drill bit, make a pilot hole. Then use 1/8-inch,
¼-inch and 5/16-inch drill bits respectively and enlarge the hole.
Mark the top of the engine dome for ignition module and ignition battery
installation by tracing the outside of the ignition box and battery.
Insert blind nuts and using a 4.5mm ball driver along with the 1-inch standoff
needed for the engine installation, pull the blind nuts in the engine dome.
engine dome preparation For da-120 • • •
Summary of Contents for Composite QQ Yak-54 2.6m
Page 99: ...99 ...
