29
Section 12: Installing the Rudder,
Elevator and Throttle Linkage
Continued
Step 8
Locate the nose wheel steering control wire (17
3
/
4
" non-threaded)
and make a Z-bend on one end. Slide the wire through the
pre-installed steering tube in the firewall and through the easy
connector on the rudder servo. Remove the steering arm from
the nose gear and connect the Z-bend. Re-install the steering arm
on to the nose gear.
Step 9
With the rudder servo and nose wheel at neutral (centered), tighten
the setscrew on the easy connector.
Step 10
Locate the rudder control wire (25
1
/
2
") and slide it through the
pre-installed rudder tube in the left rear top of the fuselage.
Connect the clevis to the rudder control horn. With the servo
centered and the rudder at neutral mark the rudder wire where it
crosses the outer hole of the servo arm.
Step 11
Remove the control wire and make a 90-degree L-bend as shown.
Cut off the excess wire 5/16 from the bend. Remove the clevis
and slide the control wire through the tube from inside the fuselage
and connect the wire to the servo arm using an L-bend keeper.
Thread the clevis back on to the wire and reconnect the clevis to
the control horn on the rudder.
