•
Read your Owner’s Manual thoroughly before using the inversion table.
•
Test the table for smooth and steady rotation before inverting.
•
For your reference, the table’s serial number can be found on a sticker mounted to the motor housing.
•
Please complete and mail your warranty card, or submit it on-line at www.TeeterHangUps.com.
You are finished assembling your Power II
TM
Inversion Table. Please remember:
ASSEMBLY
Figure 2
STEP THREE
Secure main shaft (P1-2100) to bed frame assembly (P1-1000)
•
Remove the locking knobs (P1-1003) from the holes in the main shaft
(they are pre-assembled for shipping purposes).
•
Insert the main shaft into the bed frame assembly. (See Figure 2)
•
Line up the holes on the back of the bed with those on the main shaft.
Insert and tighten both locking knobs to secure the main shaft to the bed
frame assembly.
STEP FIVE
Connect cord to the power source
•
Connect the cord to your power source* and rotate the bed upright using
the power control switch. Make sure the table operates smoothly.
*
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or breakdown, grounding provides a
path of least resistance for electric current to reduce the risk of electric shock. This product
is equipped with a cord having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER
- Improper connection of the
equipment-grounding conductor can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the product is properly grounded.
Do not modify the plug provided with the product - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
STEP FOUR
Secure handles (P1-1015) to bed frame assembly (P1-1000)
•
Insert and tighten the handles into the arms on both sides of the bed frame
assembly. (See Figure 3)
Figure 3
Assembly Instructions #LP1025 Pg. 2
For information about the Teeter Hang Ups
®
2-year warranty, or if you have any problems assembling the
equipment or questions about its use, please contact Customer Service at the appropriate location below:
USA & Canada:
STL Inc.
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(email) [email protected]
(web) www.TeeterHangUps.com
Patent applies.
Teeter Hang Ups
®
is a registered trademark of STL
Inc. and Inversion International, Ltd.
Specifications subject to change without notice.
© COPYRIGHT 2004, STL Inc. and
Inversion International, Ltd.
International Law Prohibits Any Copying, 01/04-1
International:
Inversion International, Ltd.
PO Box: AP 59245, New Providence Island, Bahamas
(Phone) +1-242-362-1001
(Fax) +1-242-362-1002
(email) [email protected]
(web) www.InversionInternational.com
front frame
rear frame
Figure 4
