The luminaire must be installed by a professional electrician.
Always switch the power off when wiring the luminaire.
Ensure input voltage conforms to the voltage range of product.
Ensure wires are securely connected.
Before switching on, ensure that all the wiring is correct.
Warranty is void if product is not installed according to the instructions.
WARNING
For more information
www.haneco.com.au
1300 001 LED (533)
Installation Instructions
Cut strip to length at indicated intervals (every
167mm) using a sharp knife or scissors. Ensure
care is taken to avoid damage to terminals.
Apply sealant on end of strip. Ensure full coverage
to maintain IP65 rating.
Ensure that surface is clean and dry by using an
isopropol alcohol.
Peel off backing tape and fix into position.
Connect strip to 24VDC constant voltage driver.
Fasten driver to surface with screws.
Secure strip by fastening saddles to surface.
1
3
5
2
4
6
FLEXION II
HANECO LED FLEXION INSTALLATION GUIDE
