HandyWave HandyPort Series, User Manual, Page: 9 / 9

9
3.4.2. Command List for Remote Device
To change the configuration for a remote device via over-the-air, firstly you have to use a
command “O” at the local device. The following are a procedure for changing configuration of
remote device via over-the-air.

Configure a remote device at the local device.

Save changes at the local device.

Make a wireless connection between the local device and remote device
(automatically).

Send changes from the local device to the remote device (automatically).

Apply changes at the remote device and reboot (automatically).
Item Syntax Description Remarks
1. Connecting
address
A Addr <Enter> Set a connecting address for remote
device.
2. Baud rate B Baud Rate Change the baud rate for the remote.
3. COM port C COM Port This is only valid in mode 2.
4. PIN code
E PIN <Enter>
Authentication Off: Type <Enter>
Authentication On: Type up to 11
characters
Paired adapters should have
a same PIN code.
5. Connection mode
M Mode
Set a connection mode for remote.
6. Friendly name N Name <Enter> Set a friendly name up to 11 characters
for remote.
7. Parity Bit
P Parity
Set the parity bit. 0: None, 1: Odd 2: Even
8. Stop Bit
S Stop
Set the stop bit. 0: 1 Stop, 1: 2 Stop
9 View
V
Display configuration information for
remote
10. Exit X Save changes and return to main menu.
11. Usage ? Print the usage.
Remarks1: To configure a remote device via over-the-air, a local device must be able to
make a connection to the remote device.
Remarks2: You can change a PIN code for the remote and local device as follows:
Change a PIN for remote at the local -> Apply it. -> Change a PIN for local and apply it.
Remarks3: Once you change a connecting address, and connection mode for the remote,
the local device won’t be able to make a connection to the remote device.