Handy Home Products Monterey, Instructions Manual

Page: 7 / 20

7
Monterey
FLUSH
Gusset Bracket
(8) 1-5/8"
Screws into
each Gusset
VIEW FROM OUTSIDE
VIEW FROM INSIDE
2-1/2"
(6.3cm)
Gap may vary in
between Gussets
All Size Gazebos
2 Right and 2 Left
Gussets with 4 holes in center
Rough sawn
Cedar side
facing down
Point
Towards Center
of Gazebo
4 Hole
Gussett
Door Panel
3
INSTALLING
GUSSET
BRACKETS
❑
6 pcs. Plywood Gusset Brackets
❑
4 pcs. 2 left and 2 Right Gussets
3-A
3-A: Install Gusset Brackets with Rough
sawn Cedar side facing down using
eight 1-5/8” screws for each Gusset.
Make sure that the Gusset Bracket is
flush to the inside of the Wall Panel and
that the inside corner is directly over
inside corner of Wall Panel as shown in
Fig. 1. The Gusset Bracket should
overhang the outside edge of the Wall
Panel by 2-1/2” as shown in Fig. 2. This
step may require some pulling of the
Wall Panel to bring it into proper posi-
tion. Tip to tip measurement on Gussets
is 46-7/8” for 10’ Gazebo and 46-3/8” on
12’ Gazebo and 46” for 14’ Gazebo. The
gap between Gussets may vary. Note:
For all sizes of Monterey, find the 2 right
and 2 left Plywood Gusset Brackets that
have the extra holes drilled, see Fig. 3.
These will go above door and opposite
wall.
Fig.1
Fig.2
PARTS LIST 10’ GAZEBO
PARTS LIST 12’ GAZEBO
❑
8 pcs. Plywood Gusset Bracket
❑
4 pcs. 2 left and 2 Right Gussets
❑
10 pcs. Plywood Gusset Bracket
❑
4 pcs. 2 left and 2 Right Gussets
PARTS LIST 14’ GAZEBO
Note: Use wood glue
between Wall Panels and
Gussets for added
strength and to meet
some local building
codes. Temporarily
install all gussets with
1-5/8” screws to align
walls. Remove one
gusset at a time, apply
glue, and reinstall all
screws. Continue for all
Gussets.
Fig.3