13cm
125-135cm
1
2
4
~
Motor
Heat switch
Ion
generator
Heater
BKR
sensor board
Power board
flat cable
Wire drawing
3
Please note:
There must be a minimum of 1.1 meters allowance from the floor to the
base of the hand dryer.
Installation instructions
1.Use template to mark the required position on the wall. Do not mount
the Dillo over a shiny surface as it will activate the sensor.
2.Do not place anything in the area where the sensor is located.
3.Drill 4 holes as per the template. Place the raw plugs in the holes.
4.Loosen the screws from the Dillo and remove the cover.
5.Position the unit upon the template and secure with the 4 screws.
6.Replace the cover and secure.
Usage instruction
Place hands under dyer. The unit will start automatically and shut off after
50 seconds. This can be re-activated immediately if required.
