H&S LOADMASTER 2X, Operator'S Manual

Page: 18 / 34

-16-
1. If you are assembling the 2X Box refer to the appropriate assembly instructions.
2. Make sure that all bolts are tightened.
3. Lubricate the
2X completely. (See Lubrication Chapter in this manual).
4. Check all taillights that they are functioning properly.
SET-UP & ASSEMBLY
Note: Determine right and left side of the
2X
by viewing it from the rear. If instructions
or parts lists call for hardened bolts, refer to Cap Screw Torque Values page to identify.
PREPARING FOR OPERATION
• Properly lubricate the 2X before operating. Refer to the Lubrication Chapter of this manual for locations.
• Inspect the tractor hitch & wagon for fatigue, cracks, loose hardware, etc. before connecting the tongue
of the wagon to the towing vehicle. Do not use an inadequate pin which may bend or break under
severe conditions.
• Attach the H&S safety chain. Pro vide only enough slack for turning.
• Clean all hydraulic couplings and connect them to the trac tor or towing vehicle.
* GPM’s required to operate
the 2X
- 35
* Tractor hydraulic reservoir capacity - 60 gallons
* Recommended pressure: 2,800 PSI Min.
• Do not operate the wagon near overhead power lines or other obstructions. Electrocution and or
damage to the wagon may occur.
• Operate the box through the lift cycle several times powering it at the end each way to purge the
system of air and rephase the system.
• Be sure to check the oil level in your tractor and add oil after cycling if needed.
PREPARING THE
2X