8. Installing the Tool — Horizontal
Mount the Miter Mandrel on to the center shaft using
two mounting bolts from the wedge cone. Suspend
the tool with the lifting frame and slide the Mandrel
into the pipe to approximately the depth that the
Gauge Assembly will position it.
[IMPORTANT—Mark
the location of the extension legs in the pipe.
These legs must be in this position to assure
alignment of the bolt holes when the tool is finish-
mounted on the Mandrel.]
Tighten the extension
legs inside the pipe sufficiently to hold the Mandrel in
place. Remove the two mounting bolts from the center
shaft flange and swing the tool out of the way. Loosen
the Extension Legs just enough to allow adjustment
of the Mandrel in the pipe. Follow instructions #4, #5,
#6 and #7 to complete the installation. An offset 1-1/8"
wrench has been provided to assist in tightening the
Extension Legs against the pipe wall.
