[email protected]
handandeyestudio.co.uk
©Oc
tober 2022
Lighting for all the senses.
Isla Wall EU/UK
Assembly Instructions 2/2
3 Connect lamp to driver
Connect the low voltage cables from the driver to the
LED cables ensuring to the correct polarity as shown in
the wriring diagram 3.
Adjust cable length to suit.
Note!
•
Ensure mains power is switched off
•
Check the driver is set to 350mA if the driver has
multiple mA settings!
•
Test lamp is working before securing to wall
4 Check lamp is facing correct direction
The light has a correct up and down side. The LED (3) can
slide off the LED fixing block (5) if located upside down.
Ensure the the fixing block stop is located at the bottom
of the lamp. See diagram 4.
5 Secure lamp to wall
Locate the ceramic shade against the wall and align the
top fixing hole with the top fitted rawplug heavy duty
plasterboard fixing (7). Thread the brass bolt (8) through
the shade and into the threaded rawplug (7). Tighten
gently using fingers or a small screw driver to fingertight.
Do not overtighten as this may crack the ceramic.
Repeat process on bottom fixing position.
Note!
•
Do not overtighten fixings screws
Diagram 4
Correct lamp direction
Diagram 3
Wiring diagram
- Negative (BLACK)
Wago 221
+ Positive (RED)
Wago 221
LED 1
LED 2
Driver
Low voltage
UPWARDS FACING LED =
BLACK HEATSINK VISIBLE IN
FIXING BLOCK
