Cordless Scanning System Quick Start
3
Proper Disposal of the Charge Pack
When the charge pack has reached the end of its useful life, the
charge pack should be disposed of by a qualified recycler or
hazardous materials handler. Do not incinerate the charge pack
or dispose of the charge pack with general waste materials.
Contact Hand Held Products (see page 7) for recycling or
disposal information.
Charging Your Charge Pack
(CLESS/NIMH/S)
Charge the charge pack by following the steps below:
1. Detach the charge pack from the bottom of the scanner.
2. Fully charge the charge pack. Plug the
charge pack directly into any common 120
V AC outlet in North America. If outside
North America, use the custom charge strip
or adaptor.
3. The LED on the bottom of the charge pack
blinks red temporarily as part of the charge
initialization sequence. After initialization,
the LED remains solid red while the charge
pack is charging. The LED shows green
when the charge pack is fully charged and
ready to use.
Note: Recharge Time: 6 hours at any voltage at
20
°
C (68
°
F.)
4. After the charge pack is fully charged, attach
it to the cordless scanner by pressing the pack firmly (align the prongs on
the pack with the mating receptacles) in the base of the scanner until the
release buttons click, holding the pack firmly in place. (
When you attach a
charged charge pack to the cordless scanner, you will hear a single beep.)
5. If you have not set up your Cordless System, refer to “Setting Up and
Connecting the Cordless System” section in the System Manual for
instructions.
When the charge pack needs recharging, the yellow LED on top of the scanner
pulses in short, continuous blinks when the trigger is pulled. If the LED stops
flashing when the temperature lowers or you do not use the charge pack for
some time, you still need to charge the charge pack.
Press Release Buttons
(2 Places)
Summary of Contents for SCANTEAM 2070
Page 4: ...ii ...
