3
Reading Techniques
The view finder
projects an aiming
beam that should
be centered over
the bar code, but
can be positioned
in any direction for
a good read.
Hold the imager over the bar code, pull the trigger,
and center the aiming beam on the bar code.
The aiming beam is smaller when the imager is
closer to the code and larger when it is farther from
the code. Hold the imager close to smaller bar
codes, and farther away from large bar codes to get
a proper read.
If the bar code is highly reflective (e.g., laminated),
you may need to tilt the imager at an angle so the
bar code can be scanned.
Note: If the imager beeps 3 times when scanning a
bar code, the link has not been established.
If the imager beeps once, the link has been
established.
Factory Defaults
The following bar code resets all factory defaults.
Factory Default
