C H A P T E R 7 U S I N G T H E D O L P H I N 7 2 0 0 H O M E B A S E
108
108
108
108
Communicating with the Dolphin Terminal
To communicate with the Dolphin and any other devices connected to the
HomeBase:
1.
Insert the Dolphin into the terminal well of the HomeBase. If the Dolphin is in
sleep mode, it will awaken into active state.
2.
The CHARGING MAINBATT LED on the HomeBase will turn on. If the
Dolphin does not turn on, or the LED does not light up, make sure that it is
properly seated in the terminal well and that the power supply is properly
connected to the HomeBase and plugged into a functioning AC outlet.
3.
Start your application on the Dolphin terminal or the host computer. Data can
then begin transmitting between the terminal and the devices connected to the
Dolphin HomeBase.
When data transfer begins, the COMM LED on the Dolphin HomeBase will blink red
and green. If the HomeBase will not communicate with the Dolphin, check the port
connections to ensure that the HomeBase is correctly configured. See
Chapter 9,
Troubleshooting
, for more information.
Summary of Contents for 7200/UG
