Hamwells HomeSpa, User Manual

Page: 48 / 53

HomeSpa user manual | 2020 v1.5
48
The HomeSpa has a number of warnings that need to be observed.
You can see them at the bottom of the screen
Warnings
No filter
• Problem: filter is not (correctly) placed in front of the pump.
• Effects: pump can not be activated, so FreshCycles and coils are
not possible.
• Action: p lace filter.
Hot water safety activated
• Problem: the water has become too hot and the pump has been
automatically shut down.
• Effects: FreshCycles is not possible as long as the temperature is too high.
• Action: Normally the error is automatically reset.
A
Terug
00 pump : OK
01 NTC temperauture : OK
02 NTC connection : OK
03 thermostat position : OK
04 Thermostat temperature : error
05 water level : OK
06 PID : OK
07 cleaner : OK
08 safety switch : OK
09 smart stop timeout : OK
0A UV lamp : OK
0B Temperature request : OK
A
Terug
00 pump : OK
01 NTC temperauture : OK
02 NTC connection : OK
03 thermostat position : OK
04 Thermostat temperature : error
05 water level : OK
06 PID : OK
07 cleaner : OK
08 safety switch : OK
09 smart stop timeout : OK
0A UV lamp : OK
0B Temperature request : OK
A
Terug
00 pump : OK
01 NTC temperauture : OK
02 NTC connection : OK
03 thermostat position : OK
04 Thermostat temperature : error
05 water level : OK
06 PID : OK
07 cleaner : OK
08 safety switch : OK
09 smart stop timeout : OK
0A UV lamp : OK
0B Temperature request : OK
Quick rinse is required
• Problem: the cleaning program (hot clean / deep clean) was interrupted during
the last use or the power has gone off.
• Effects: if this is not done, the FreshCycles will not start up.
• Action: start quick rinse (see page 20) or ignore this warning (see page 38) .