ELEKTRA 2000 Hamtronix
7
BASIC OPERATION
CONTROLLING YOU REPEATER REMOTELY
With exception of audio levels, all functions are controlled remotely with your radio DTMF keypad.
COMMAND SINTAXES
Commands are as following:
PPPPFF0#
Where:
PPPP
4 digits password
FF
2 digits function
O
1 digit option
#
Enter
See the command for change the sound of courtesy tone:
1234066#
Your controller will answer valid commands with two high frequency confirmation beeps (function 08
must be enabled). If the entered command is invalid, a long, low frequency tone will be heard. The
command must be entered completely in one transmission. If you release PTT switch before you
complete a command, the entered numbers will be discarded.
You can enter more than one command without having to release PTT between them. # acts like a
command separator. If entering a command and you made a mistake, just press * to clear the entered
string and start over.
Note 1:
DTMF commands without a correct password will not generate an error message. They will just
be discarded.
Note 2:
Some commands don’t require an option or may require extra procedures. These exceptions will
be explained in details at function description.
Note 3:
Default password is 1234. After get acquainted with the controller commands, change this
password.
WARNING
To get a correct decoding of DTMF tones, the signal must be free of noises or jamming. If the
repeater is busy, wait until it becomes free prior to sending commands.
