GB
54
APPLICATION OF DETERGENT OR DEGREASER
1�
Apply the solution on a dry surface�
2�
Work from side to side, from below and up, on vertical surfaces�
NOTE:
Do not wet the surface before cleaning, this produces inferior cleaning results�
NOTE:
Do not work on hot surfaces or in direct sunlight, this can cause the chemicals to damage the surfa-
ce� Do not allow the chemicals to dry on the surface, this can damage the surface� Do not hold the nozzle
too near the surface, this can damage the surface�
3�
Allow to act for a few minutes�
4�
Flush with clean water at high pressure� Flush from below and up and then from up and down on
vertical surfaces� Keep the nozzle 15–20 cm from the surface at an angle of 45° and spray with a
wide jet�
NOTE:
Disconnect the hose for the chemicals when chemicals are not used�
APPLICATION OF WAX
1�
Apply any wax immediately after cleaning� Place the injection hose in the wax container�
2�
Apply the wax sparingly and uniformly� Apply on a wet surface from below and up for best results
without stripes�
3�
Remove the injection hose from the wax container and rinse off surplus wax� NOTE: The surface
can become misty if surplus wax is not removed�
4�
Wipe dry to reduce the risk of water stains�
AFTER USE
After using chemicals remove the hose from the chemicals container and put it in a container with clean
water� Continue spraying water at low pressure until the hose is flushed clean�
MAINTENANCE
CONNECTIONS
To counteract leakage, clean and lubricate all connections regularly with lubricant recommended by the
manufacturer�
NOZZLE
Clean the nozzle immediately if it gets blocked, otherwise the pump can be damaged�
WARNING:
Switch off the machine and disconnect the spray head from the spray gun before cleaning the
nozzle, otherwise there is a risk of personal injury�
1�
Release the head from the spray gun�
2�
Clean the nozzle with a stiff wire, e�g� a straightened out paper clip�
3�
Flush the water backwards through the nozzle�