4
Assembly
1
Setting up the frame
□
Stand frame upright. Starting at the corners, with a partner
standing on the opposite side, grasp the two outer legs
slightly lift the frame off of the ground and step backwards
stopping at full arm’s length.
2
Attaching the vent cover
□
Unfold the main canopy and vent cover, place the vent cover (C)
over the center of the top of the frame. Gently pull the corner
pockets of the vent cover (C) on the 6 short roof tubes
in the center of the frame.
3
Expanding the frame
□
Each partner should then grasp the bottom rails of the middle
frame section (cross beam) where it forms a diamond. Lift frame
slightly off the ground and slowly walk backward until the frame
is extended to 80%.
WARNING:
as this may result in the bending of cross beams.
4
NOTE:
The canopy top and frame are shipped unattached to avoid
damage. First time set-up requires that the canopy be attached
to the frame. Once the canopy top is permanently attached,
set up and take down are easily accomplished within seconds.
IMPORTANT:
Please do not use too much force during
set-up.
A
C
Grab Here
Attaching the main canopy
□
Place the main canopy (B) over the top of the frame.
Use the hook and loop pads to secure each corner of the main cover (B)
to the frame at the top of each leg.
B
