12
Mounting the fan - Standard
□
Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws.
□
Install the remaining two mounting screws into the holes in the
canopy (C) and tighten firmly.
□
Install the decorative canopy ring by aligning the ring’s slots
with the screws in the canopy (C). Rotate the ring counter-
clockwise to lock in place.
9
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
Close-to-Ceiling Mounting
WARNING: Locking slots of ceiling canopy are provided only as an
aid to mounting. Do not leave fan assembly unattended until all
four canopy screws are engaged and firmly tightened.
□
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws firmly.
□
Install the remaining two mounting screws into the holes in
the canopy (C) and tighten firmly.
□
Install the decorative canopy ring by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
counter-clockwise to lock in place.
□
You may now proceed to attaching the fan blades.
Assembly - Hanging the Fan (continued)
A
C
A
C
Wrapping the extra wire
10
□
Gently wrap the excess wire around the mounting bracket,
under the receiver.
□
Secure with electrical tape.
NOTE:
Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan to the receiver.
