background image

 2 
 

Table of Contents 

 

Table of Contents .........................................................2

 

Safety Information ........................................................2

 

Warranty                .........................................................3

 

What is Covered   ....................................................................

3

 

What is Not Covered  ..............................................................

3

 

Pre-installation   ............................................................4

 

Tools Required      ...................................................................

4

 

Hardware Included  ................................................................

4

 

Package Contents    ................................................................

4

 

Installation   ................................................................... 5

 

Operation     ................................................................... 8 
Troubleshooting ......................................................... 10 
 Cable Selection Chart  .............................................. 10 

 

Safety Information  

IMPORTANT SAFETY INFORMATION TO REDUCE RISK OF FIRE OR INJURY. 

 

Do not install within 10 feet (3 m) of a pool, spa or fountain. 

 

For use with low voltage outdoor landscape lighting system only. 

 

There are no serviceable parts inside the power supply unit. DO NOT DISASSEMBLE. 

 

Do not submerge transformer. 

 

Do not connect two or more transformers in parallel. 

 

Do not use with a dimmer. 

 

Plug the power supply unit directly into a GFCI wet location outlet. 

 

Do not use an extension cord. 

 

The maximum output of this transformer is 45 watts. Do not overload the transformer. Be sure that the total cumulative wattage of all 12 
volt fixtures connected to the transformer is equal to or less than 45 watts.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PLEASE NOTE: This landscape light system must 
be installed in accordance with all local codes and 
ordinances. If you are experiencing problems, 
contact a qualified electrician.  

 

WARNING:

 

Changes or modifications to this unit not 

expressly approved by the party responsible for 
compliance could void the user’s authority to operate 
the equipment.

 

 

Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in 
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of the following measures: 
—Reorient or relocate the receiving antenna. 
—Increase the separation between the equipment and receiver. 
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
—Consult the dealer or an experienced radio/TV technician for help. 

Summary of Contents for SL-45-12A












Reviews: