6.
Rubber
washer
Blade
arm
Figure 9
Blade
Screws
Attaching the Fan
Blades
Step 1
Attach blades to blade arms using
three screws and rubber washers.
Start a screw into the
arm, do not
tighten. Repeat for the 2 remaining
screws and washers.
Step 2
Tighten each screw securely
starting with the center screw. Make sure
the blade is straight.
(Fig. 9)
blade
Repeat steps for the
remaining blades.
Step 3
Fasten the blade arms to the motor
by inserting the tab from the blade arms
to the slot in the bottom motor housing,
then tighten the two screws and washers
already installed in the blade arms. (Fig.
10)
Figure 10
Motor
Blade arm
Slot
Tab
Installing the Mounting
Plate
Step 1. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened
from the mounting ring, turn mounting plate
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 11)
Figure 11
Mounting plate
Mounting ring
Screws
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE ARMS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NO INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
