Assembly
5
2
Attaching the leg connector bracket
3
Tightening the nuts to the bolts
□
Repeat steps 1 and 2 for the left leg (B1).
□
Use the hex bolt driver (HH) to tighten all bolts (AA, BB and CC).
□
Repeat until all bolts are tight. (Do not over tighten. Over
tightening may strip bolts).
□
Cover all bolts (AA, BB and CC) with covers (FF and GG).
1
Attaching the right leg
□
Attach the chair frame (A) to the right leg (B2) by using three
1/4 in. x 15mm bolts (AA), a 1/4 in. x 35mm bolt (CC) and
Ø19 x Ø8.5 x 7mm washer (EE) as shown in the diagram.
□
Guide the bolts through the holes in the right leg (B2) and into
pre-drilled holes in the chair frame (A).
□
Hand tighten only.
□
Attach the leg connector bracket (C) to the right leg (B2) by
using two 1/4 in. x 20mm bolts (BB) and Ø6.5 x 1.0mm
washers (DD) as shown in the diagram.
□
Guide the bolts through the holes in the leg connector bracket
(C) and into pre-drilled holes in the right leg (B2).
□
Hand tighten only.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
A
GG
C
B2
FF
CC
EE
GG AA
B2
BB
B1
DD