6
598-1270-00
TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide.
No Service Parts Available for this Product
SYMPTOM
POSSIBLE CAUSE
SOLUTION
Lights will not come
on.
1. Light switch is turned off.
2. Lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new
installation.
1. Turn light switch on.
2. Check lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
Lights come on in
daylight.
1. Light control may be installed in a relatively
dark location.
2. Light control is in TEST.
1. The fixture is operating normally under these
conditions.
2. Set control switch to 1, 5, or 10 minutes.
Lights come on for no
apparent reason.
Light control may be sensing small animals or
automobile traffic.
Reduce sensitivity.
Lights stay on continu-
ously.
The sensor may be picking up a heat source
like an air vent, dryer vent, or brightly painted,
heat-reflective surface.
Reduce sensitivity.
Lights flash on and
off.
Light control is in the TEST mode and warm-
ing up.
Flashing is normal under these conditions.
