5
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly
1
Aligning the T-rock mechanism
2
Assembling the T-rock
□
Place the chair seat (A) upside down on a clean smooth
surface.
□
Align the T-rock (C) to the U-bar (1) of the chair seat (A).
Place the metal plates of the T-rock (C) against two
plastic stoppers (2).
□
Attach each metal plate (3) on the T-rock (C) to the chair seat
(A) with two bolts (BB), two washers (CC), and one washer plate
(DD) using the wrench (GG). Insert the hardware from the top side
of the U-bar.
□
Place the metal
plate on bottom side of U-bar and attach with two
nuts (AA), two washers (CC), and one washer plate (DD) using the
wrench.
□
Tighten all the bolts using the wrench (GG).
□
Cover all bolts with the bolt caps (EE) and nut caps (FF).
FRONT SIDE
2
REAR SIDE
1
2
C
DD
DD
CC
AA
FF
CC
3
C
A
AA
EE
BB
CC
EE
BB
CC
DD
FF
IMPORTANT:
It is very important to position/assemble
the washer plate (DD) completely. Carefully follow the
diagram below.
WARNING:
Do not try to put the T-rock on the rear side.
See the diagram below.
IMPORTANT:
Please identify the front side and rear side
and put the T-rock on the front side only.
IMPORTANT:
You may need to loosen pre-installed bolts
on the T-rock if the T-rock and the U-bar cannot be lined up.