4
Installation
1
Attaching and installing the
fixture
2
Connecting the wires (continue)
□
Prepare a hole in the installation location. Use a tool such
as a shovel to prepare the installation hole to ensure that
the hole is not larger than the Fixture (A).
□
Bury the fixture head (A) into the ground.
DANGER:
Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
Note:
Do not use a hammer. If the ground is hard, use
water to soften it or a trowel to loosen the soil.
WARNING
: The Wire Connector (3) has sharp edges for
piercing the main low voltage cable. To avoid injury, do not
touch the metal contacts
CAUTION
: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit Cable
IMPORTANT
: Protect the wiring by routing it in close
proximity to the light or next to a building structure such as a
house or deck.
Do not bury the wiring by more than 6in. (15.24cm) in order to
connect to the main secondary wire
□
Unlock the connector (2 & 3) by pushing in from both sides and
lift.
□
Align and fit the low voltage landscape wire (not included) from
the transformer (not included) horizontally into the center slot of
the wire connector for landscape wire (2) by unlocking the
connector (2 & 3) by pushing in from both sides and lift.
2
Connecting the wires
□
Push down the wire from the transformer (not include) to
make sure the wire is secure in the slot of the wire connector
(2) for landscape wire and laid flat as shown in the picture
below.
□
Press the wire connectors (2 & 3) back together until they
lock and there is no gap between the two connectors (2 & 3).
□
Once the connectors are in place, it is recommended to wrap
them with electric tape (not included).
□
After the fixture is installed, turn on the transformer.
□
Choose your favorite correlated color temperature (CCT)
from the 3 options: 2700K warm white, 3000K soft white
and 4000K bright white
□
Push the CCT button (4) to switch between warm white,
soft white and bright white to make your selection
3
Adjusting the temperature of the
light
Switch Options:
2700K Warm White
3000K Soft White
4000K Bright White
NOTE
: The factory setting for the correlate color temperature
(CCT) is 3000K Soft White
4
