10
Installing the Light Kit
Attach the light kit to the switch housing by
feeding the light kit wires (black and white)
through the hole of switch housing and then
screw it onto the switch housing by nut & lock
washer. Be sure it is tight enough to prevent
light kit from vibrating loose. (Fig. 17)
Locate two single white and blue wires in the
switch housing labeled FOR LIGHT.
Make the polarized plug connections:
- White to white
- Blue to black
While holding the light kit assembly under
your fan, snap together the wire connection
plugs.
Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 18)
Place the light shade on the top of bulb holder,
1.
2.
3.
4.
5.
6.
be sure to position the metal arms on the top of
sockets correctly, the incorrect installation may
cause the touch of light shades and light kit and
scratch the light shade. (Fig. 18)
Install 3 x 40W candelabra bulbs (included).
Restore power and your light kit is ready for
operation.
7.
8.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Figure 17
Figure 18
Switch Housing
Light kit
Nut
Lock washer
Screws
Bulbs
Mounting Plate
Light Kit
Assembly
Wire Connection
Plugs
Light Shade
Bulb Holder
Metal Arm
Socket
Socket
