PACKAGE CONTENTS
Assembly and Installation
Item #1007 893 197
Model#
LBO-N1BR3000K6B
□
□
□
□
A - Fixture Head
D - Wire Connector
□
Use and Care Guide
LED Low Voltage Walk and Path Light
A
B
Attach the fixture head (A) to the fixture post (B), by inserting the fixture
post (B) into the fixture head (A)(Fig 1) and twisting it clockwise. (Fig 2)
□
Place the wire connector (D) on opposite sides of the main low voltage
cable (sold separately) from the transformer (sold separately) where the
fixture will be located.
Align and fit the main low voltage cable horizontally over the slot of the
wire connector (D).
Press the wire connector (D) together until it is locked around the main
low voltage cable. The preset prongs will pierce the cable insulation and
establish contact with the electrical wire inside.
Once the wire connector (D) is in place, it is recommended to wrap it with
electrical tape (sold separately).
After all fixtures are installed, turn on the transformer.
C - In-Ground Stake
C
NOTE:
Do not use a hammer. If the ground is hard, use water
to soften it or a trowel to loosen the soil.
WARNING:
Never push the fixture into the ground by the
fixture head (A) or use a hammer to insert the in-ground
stake (C) into the ground.
WARNING:
The wire connector (D) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-16
AWG type underground low energy circuit cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the
light fitting, or next to a building structure such as a house or a deck.
The landscape wire and connector can also be hidden under stone
or buried under grass at a maximum depth of 6 in. (12.54 cm).
Do not install the fixture within 10ft of a pool, spa, or fountain
Do not submerge the fixture in water.
Push the stake assembly into the ground by grasping the fixture post.
Do not push on the fixture head (A).
□
□
B - Fixture Post
D
(Fig 1)
(Fig 2)
A
B
A
B
B
C
(Fig 3)
B
C
(Fig 4)
(Fig 5)
A
(Fig 6)
(Fig 6)
(Fig 6)
(Fig 6)
(Fig 6)
Attach in-ground stake (C) by inserting into the bottom of the fixture
post (B) (Fig 3) and twisting clockwise. (Fig 4)
(Fig 6)
1. Attaching and installing the light
2. Connecting the wires
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
