Instructions to Convert Unit to Vertical Duct Configuration
6
1. Remove the 12 screws holding the Duct in place.
2. Turn the Duct 90 degrees counter-clockwise and slide flange under top as shown.
3. Insert 3 screws at the bottom of the duct.
4. Place the Duct Mount Strips over the side Duct Flanges and insert 3 screws each into the holes provided.
Proceed with the installation as normal. The Side Sealer Channels will go on the same flanges as for a horizontal duct.
You may use the Side Sealers provided to close off the window above your cooler’s duct.
LIMITED WARRANTY
This warranty is extended to the original purchaser only.
It does not cover damages incurred during shipping or
through accident, neglect, or abuse by the owner. Essick Air Products does not authorize any person or representative to
assume any other or different liability in connection with this cooler.
TERMS AND CONDITIONS OF WARRANTY
The
BOTTOM PAN
is guaranteed against leakage due to rusting out for
Five Years
. All other original parts provided by
Essick Air Products are warranted against defects in material or factory workmanship for One Year.
EXCLUSIONS FROM THE WARANTY
Essick Air Products is not responsible for incidental or consequential damage resulting from any malfunction.
Essick Air Products is not responsible for any damage occurring from the use of water softeners, chemicals, descale
material, or if a higher horsepower motor than what Essick Air Products recommends is used in the unit.
Essick Air Products is not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair
and/or replace parts.
HOW TO OBTAIN SERVICE UNDER THIS WARRANTY
Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response
from the Dealer, contact Customer Service Department: Essick Air Products inc.;
5800 Murray Street, Little Rock,
Arkansas 72209. 1-501-562-1094.
