5 HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Installation
1
Installing the doorbell
□
Plug in the doorbell (A) at the desired location.
VO
L +
VO
L –
Li
ght
Sy
nc
Mu
sic
2
Removing the battery tab
□
Remove the back of the push button (B) by
pushing in the tab on the bottom with a small
screwdriver (not included).
□
Remove the orange battery tab from the push
button (B).
ON
1
2
3
Testing the push button and
doorbell
□
Temporarily position the push button (B) where
it will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE:
Do not permanently mount the push button until
the push button and doorbell are working properly.
NOTE:
The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
4
Mounting the push button
Use either screws (AA) or double-sided tape (BB) to
mount the push button (B).
□
To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab on
the bottom with a small screwdriver. Place the
push button back on the door jamb and mark
the two screw holes. Drill two 1/16 in. pilot
holes. Attach with screws (AA) and snap on the
front of the push button (B).
□
When attaching the push button (B) with
double-sided tape (BB), remove the paper from
both sides of the double-sided tape (BB) and
apply to a clean surface.
NOTE:
Remove material in screw holes (if needed) before
mounting with screws.
A
B
A
B
AA
