44
|
Hampton® H35-10 Direct Vent Freestanding Gas Stove
|
44
maintenance
Replacing the Fan:
Reverse the above steps (1 - 4). Make sure the fan
wires and the ground wire are reattached.
Hint for pushing fan down onto pins - rub a bit of
dish soap on the grommet so it will slide more easily
onto the pin. Check to make sure the fan is seated
properly on the pins - try to move the fan back and
forth, there should be no noise, if there is check that
the grommets haven't come loose.
Disconnect the ground wire
Disconnect the connectors
ACCENT LIGHT BULB
REPLACEMENT
1.
Turn off stove and allow to return to room tem-
perature.
2
. Shut off electrical supply
3.
Lift off cast top and place on a soft surface.
4.
Loosen bolts securing cast front–slide light as-
sembly bracket upward to release.
5
. Remove two (2) screw to remove bulb housing.
Lift light assy bracket off bolts to install
bulb
Remove two screws in locations shown
6
. Replace bulb.
Note:
Oils from hands will shorten the life of the bulbs,
do not handle bulbs with bare hands.
7
. Reverse steps to reinstall.
3) Undo the top cast grill mounting bolts using
7/16" or 11mm socket.
6.
Slide safety screen upwards to remove.
SAFETY SCREEN
REPLACEMENT
1.
Turn off stove and allow to return to room tem-
perature.
2.
Lift off cast top and place on a soft surface.
4.
Slide the light assembly bracket out of the way.
5.
Remove the top cast and place on a soft surface.
7
. Replace screen and reverse steps to reinstall.
Red
Red
