9.
Installing the Light Kit
Screws
Light kit
Reverse
switch
Switch housing
Wire
connector
N O T E
: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
1.
ocate two single white and blue wires in
the switch housing labeled "FOR LIGHT".
Make the polarized plug connections:
- White to white
- Blue to black
2.Carefully push all wires back into the
switch housing. Attach the light kit fitter by
aligning its keyhole slots with the three
screw holes and the reverse switch on the
side of the switch housing. Tighten the
three screws securely to prevent the light
kit from vibrating loose. (Fig. 17)
3.
nsert the glass, then
gently tighten the thumbscrews by hand
evenly to the glass. DO NOT OVER
TIGHTEN. (Fig. 18)
4.Install 3 x 40W
bulbs (not
included).
5.Restore power and your light kit is ready
for operation.
While holding the light kit under your fan,
l
Mount the glass shades to the light fixture
by unscrewing partway the thumbscrews
on the glass holders, i
candelabra
Figure 17
Bulbs
Glass shade
Thumb screws
Figure 18
