background image

 3

•  Combustible material should not be within 72 inches of the top of the unit, or within 48 inches 

around the entire unit. 

•  Keep the appliance area clear and free fr

vapors and liquids.

• 

ning, turn the gas valve off. Wait 5 minutes before repeating the initial 

•  Do not add water into the unit. 

•  Do not operate unit if any part has been under water. Immediately call a qualified service 

technician to inspect the appliance and replace any part of the control system and any gas

control that has been under water.

•  Do not disconnect any part while unit is in use. 

•  Do not store a spare propane tank on or near this unit.

•  If the heating unit is indoors, detach the propane tank and leave outdoors. 

•  Always remove protective cover before operating (if applicable).

•  Do not set the protective cover over the unit until it is turned off and completely cooled down.

•  Check for leaks after not using the unit for long periods of time. 

•  Children should never operate this unit. Children must be supervised while near this unit.

•  Keep gas tank at least 5 feet away from unit when lit. (if external tank)

•  The maximum gas supply pressure is 250psi.

inspected annually and cleaned regularly.

•  Inspect all elements of this heating unit before each use. If there is damage, the burner must be 

replaced.  

•  Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)

•  Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or 

injury. 

of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas 

tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission. 

gas tank connection.

cks.

•  Children and adults should be alerted to the hazards of high surface temperatures and should 

stay away to avoid burns or clothing ignition.

•  Young children should be carefully supervised when they are in the area of the appliance.

near the appliance.

•  Any guard or other protective device removed for servicing the appliance shall be replaced 

prior to operating the appliance.

may be required as necessary. It is imperative that the control compartment, burners and 

circulating airways of the appliance are kept clean.

 

IF APPLICABLE:

•  Allow heating item to cool completely before placing on lid.

•  DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use.  

 

Summary of Contents for GFHD42













Reviews: