8.
the switch cup below the fan motor assem-
bly with the black and white wires from the
light kit by connecting the polarized plugs
(blue to black; white to white). Carefully
push all wires back into the switch cup.
3. Align the two key slots in the light kit as-
sembly with the two mounting screws and
lockwashers on the switch cup that were
loosened in step 1, place the light kit as-
sembly over the two screws, turn light kit
assembly clockwise until it locks, tighten
the two screws.
4. Re-install the two mounting screws and
lockwashers that were removed in step 1
and tighten firmly.
5. Remove the finial and hex nut from the
threaded tube, install the threaded tube onto
the stem of the light kit assembly and secure
with hex nut.
6. With power off, install the light bulbs (Max.
40W, provided) into the sockets (Figure 12).
Installing the Light Kit
and Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Remove two of four mounting screws and
lockwashers on the switch cup below the
fan motor assembly, loosen but do not re-
move the other two mounting screws and
lockwashers (Figure 12).
2. Connect the blue and white wires exiting
Figure 12
OVER LAMPING THE FAN WILL RESULT IN
THE FAN LIGHTS SHUTTING DOWN UNTIL THE
PROPER WATTAGE BULBS ARE INSTALLED.
RESET THE LIGHTS BY TURNING OFF, RE-
PLACE BULBS WITH THE POWER ON.
7. Position the glass bowl over the threaded
tube and secure with finial and finger tight-
en.
NOTE: ALLOW BULBS TO COOL COM-
PLETELY BEFORE TOUCHING OR RE-
PLACING TO AVOID ACCIDENTAL BURN-
ING OF THE SKIN.
