Operation
Before each use, be sure to inspect the hose. Replace the hose if there are any signs of cutting, wear or abrasion.
Care and Maintenance
WARNING: FUELS USED IN LIQUEFIED PROPANE GAS APPLIANCES, AND THE PRODUCTS OF
COMBUSTION OF SUCH FUELS, CAN EXPOSE YOU TO CHEMICALS INCLUDING BENZENE, WHICH IS
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND CAUSE BIRTH DEFECTS OR
OTHER REPRODUCTIVE HARM. For more information go to :www.P65Warnings.ca.gov.
1. Push and turn the control knob (J) clockwise the OFF position.
The manufacturer’s warranty will be voided by, and the manufacturer disclaims any responsibility for the following actions:
Use of any component part not manufactured or approved by the manufacturer.
Modification of the fire bowl and/or components including the gas valve assembly.
Use and installation other than as instructed in this manual.
3. After ignition, release the electric igniter button (K).
Continue to push and hold the control knob (J) for 45 seconds.
Note: The flame should be a yellow/blue color.
2. Turn the cylinder valve on the tank to close the gas supply if not in use for a long time.
1. Turn the cylinder valve on top of the propane tank counterclockwise to open the gas supply.
2. To ignite the burner ring (D):
a) Press and hold the electric igniter button (K).
b) At the same time, push in and turn the control knob (J) counterclockwise, to the LOW position.
c) Keep the the control knob (J) pushed in to light the burner ring (D).
See Figure 9
See Figure 8
Release the electric igniter button (K) and turn the control knob (J) to OFF (clockwise).
WAIT 5 MINUTES to clear out the gas!
Repeat the lighting instructions in Step 2 as above.
If ignition does NOT immediately occur
WARNING!
WARNING!
Do not place the lid or nylon cover on top of the fire pit for
at least 4 hours after use and until the fire pit has cooled.
During the initial lighting of the fire pit, stay away from the fire pit for 30 minutes as the fire
WARNING!
CAUTION:
Only use the pressure regulator and hose assembly supplied with the fire pit. The replacement
pressure regulator and hose assemblies must be specified or supplied by the manufacturer.
glass may pop and cause injury to the face or eyes.
Store the fire pit in a cool dry place away from direct sunlight.
The propane tank must be disconnected and removed from the fire pit before the fire pit can be stored indoors.
Make sure both the gas and the fire pit are turned off before changing the battery. Please refer to the process of installing the
battery (Step 2).
Use manufacturer approved or supplied replacement parts and accessories only. Use of unauthorized replacement parts
may void the warranty.
Keep the fire pit free and clear from combustible materials.
Visually inspect the burner ring for blockages (spider webs, dirt, etc.). Keep the fire pit free and clear from debris.
After the burner ring and
ODYDURFN
are completely cooled down, use a soft brush to get rid of mild stains, loose dirt and soil. Wipe
with a soft cloth.
Limited Warranty
K
J
K
J
ADVERTENCIA:LOS COMBUSTIBLES USADOS EN EQUIPOS PARA LICUAR GAS PROPANO,AS
Í COMO
LOS PRODUCTOS DE SU COMBUSTIÓN,PUEDEN EXPONERTE A SUSTANCIAS QUÍMICAS,ENTRE ELLAS
EL BENCENO,QUE EL ESTADO DE CALIFORNIA RECONOCE COMO CAUSA DE CÁNCER Y DE
MALFORMACIONES CONG
ÉNITAS Y OTROS DAÑOS AL SISTEMA REPRODUCTOR.
Para m
ás información,visite www.P65Warnings.ca.gov
